Home
Help
Search
Login
Register
OPNsense Forum
»
Archive
»
17.7 Legacy Series
»
[SOLVED] Insight / Netflow wrong interface order
« previous
next »
Print
Pages: [
1
]
Author
Topic: [SOLVED] Insight / Netflow wrong interface order (Read 3985 times)
Wayne Train
Full Member
Posts: 194
Karma: 12
[SOLVED] Insight / Netflow wrong interface order
«
on:
October 05, 2017, 02:20:53 pm »
Hi,
I'm experiencing a very strange behaviour: If I tell Netflow to listen on WAN, SYNC, VLAN1, VLAN2 and VLAN3, the presentation of insight is wrong. For example: If I select the interface VLAN1 it displayes the Sources of VLAN3.
Is there any way to fix this issue ?
I have 11 Interfaces in total, but opt1 (AMT) is not configured and 8 of 10 interfaces are vlans on a lagg-interface.
Any idea ?
Best regards,
Chris
«
Last Edit: October 13, 2017, 09:27:15 am by Wayne Train
»
Logged
Wayne Train
Full Member
Posts: 194
Karma: 12
Re: Insight / Netflow wrong interface order
«
Reply #1 on:
October 09, 2017, 10:35:33 am »
Any Ideas on this ?
Logged
franco
Administrator
Hero Member
Posts: 17473
Karma: 1587
Re: Insight / Netflow wrong interface order
«
Reply #2 on:
October 09, 2017, 11:38:15 pm »
The graph uses interfaces index numbers, they might get mixed up during boot / reconfigure. Not so nice if that's the case but I don't know the netflow subsystem used here well. Asking the question on GitHub may yield better intel.
Cheers,
Franco
Logged
Wayne Train
Full Member
Posts: 194
Karma: 12
Re: Insight / Netflow wrong interface order
«
Reply #3 on:
October 11, 2017, 09:44:03 am »
Ok. So you think after rebotting the box, the issue is gone ?
That would match my theory, because a few days ago I rebooted the failover-node and since then netflow is working correctly.
I'll try this tommorow morning and post what happened. I don't think I'm the only one experiencing this behaviour.
Thank's a lot.
Best regards,
Wanye
Logged
Wayne Train
Full Member
Posts: 194
Karma: 12
Re: Insight / Netflow wrong interface order
«
Reply #4 on:
October 13, 2017, 09:26:17 am »
Hi Franco,
I just rebootet the Master-FW and no the interface order is correct. Maybe this could also have been achieved by restarting the network on the CLI, but I was afraid that this would lead to flapping Interfaces in my FW-cluster.
I'll mark the post as "SOLVED" now.
Thanks a lot.
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
Archive
»
17.7 Legacy Series
»
[SOLVED] Insight / Netflow wrong interface order