OPNsense Forum

Archive => 17.7 Legacy Series => Topic started by: Wayne Train on October 05, 2017, 02:20:53 pm

Title: [SOLVED] Insight / Netflow wrong interface order
Post by: Wayne Train on October 05, 2017, 02:20:53 pm

Hi,
I'm experiencing a very strange behaviour: If I tell Netflow to listen on WAN, SYNC, VLAN1, VLAN2 and VLAN3, the presentation of insight is wrong. For example: If I select the interface VLAN1 it displayes the Sources of VLAN3.
Is there any way to fix this issue ?
I have 11 Interfaces in total, but opt1 (AMT) is not configured and 8 of 10 interfaces are vlans on a lagg-interface.
Any idea ?
Best regards,
Chris

Title: Re: Insight / Netflow wrong interface order
Post by: Wayne Train on October 09, 2017, 10:35:33 am

Any Ideas on this ?

Title: Re: Insight / Netflow wrong interface order
Post by: franco on October 09, 2017, 11:38:15 pm

The graph uses interfaces index numbers, they might get mixed up during boot / reconfigure. Not so nice if that's the case but I don't know the netflow subsystem used here well. Asking the question on GitHub may yield better intel.


Cheers,
Franco

Title: Re: Insight / Netflow wrong interface order
Post by: Wayne Train on October 11, 2017, 09:44:03 am

Ok. So you think after rebotting the box, the issue is gone ?
That would match my theory, because a few days ago I rebooted the failover-node and since then netflow is working correctly.
I'll try this tommorow morning and post what happened. I don't think I'm the only one experiencing this behaviour.
Thank's a lot.
Best regards,
Wanye

Title: Re: Insight / Netflow wrong interface order
Post by: Wayne Train on October 13, 2017, 09:26:17 am

Hi Franco,
I just rebootet the Master-FW and no the interface order is correct. Maybe this could also have been achieved by restarting the network on the CLI, but I was afraid that this would lead to flapping Interfaces in my FW-cluster.
I'll mark the post as "SOLVED" now.
Thanks a lot.