Fresh Install OPNsense 26.7, unable to implement vlans with Netgear MS308E

[Schwermzilla]

Hello OPNsense forum, I apologize if this is a novice problem, but it has stumped me for days at this point and I have been searching here and at netgear's forum and not found anyone sharing the same problem, I have seen some related posts which I have tried to replicate the solutions of, to no success.

Scenario: I have OPNsense 26.7.4_1 running on a 5 port miniPC (Intel N150, 128gb ssd & 8GB ram), the pc has 3 2.5Gb ports and 2 10Gb SFP ports. Currently, I am just using the 2.5Gb ports, as I want to verify vlans work before I add more complexity. To keep things simple, I am working on a reduced complexity as things weren't working in a previous, more complex state either. So, I recently did a fresh install and full update because I was at wits end.
I am only able to upload one photo here because of image size, full folder is available here: https://drive.google.com/drive/folders/1YmCybrYoM4dVkMVTz_UjtMY8Dn6Zi6km

Currently: LAN and WAN access work great, stable internet, DHCP leases working, Static IP config for the managed switch, wireless AP, and NAS.
Port 1 is WAN (igc0/Wide_Network in photos).
Port 2 is the LAN (igc1/Local_Network in photos).

Problem: I am trying to setup Port 3/igc2 as a truncated vlan port with only two tagged vlans on it;
tag 11 is the Guest_Network, tag 22 is the Surveillance_Network. I have setup the vlans, enabled them as interfaces, added static ipv4 addresses, allowed firewall access and allocated DHCP address pools (verifiable in the photos).
I have split out the Local_Network and vlans on separate ports, as I have seen others have issues with mixing tagged and untagged traffic on the same port with netgear/Opnsense.
The photo (netgear_ports) shares the mapping on the Netgear managed switch; ports 4/5 are connected to OPNSense, port 4 is paired with igc1 (Local), port 5 with igc2 (vlan Trunk).  Port 8 will go to an NVR which has POE ports for the cameras (haven't turned this on yet). Last relevant connection on the switch, port 1 goes to my wireless AP (Netgear Orbi Pro 6, SXR80) setup in AP mode, which works on local network access when tested. On the Orbi, it has been setup in Trunk mode since being in AP, I have two id's broadcasting there, one for 192.168.1.x (local) and the other for 192.168.11.x. (guest). I have tried running port 1 on the switch in trunk/uplink mode as well, but then I lose connection to the orbi in either Trunk or Access vlan 11 only (pictured). The only way it works is when it is set to access only local vlan 1; Then devices on the local wifi work fine, devices on the guest wifi connect to the Orbi but have an IP configuration error and aren't assigned DHCP leases, as expected.

My understanding of the problem, when in Trunk/Uplink mode, the Netgear switch is not seeing the incoming tagged traffic on igc2/port 5. Running in diagnostic mode shows zero "bytes received" on that port, the screenshot was captured after 30 mins or so. I am not confident OPNsense is sending anything, but I don't see any issues with my configuration from the OPNsense side.

Any help would be wonderful, I had spoken with my friend who is an SRE, and he gave me a bit of sanity check that I didn't have anything obviously setup wrong, but who knows, so I come to you all in hopes of finding a solution. THANK YOU!