System unusable after starting Zenarmor since 26.1

[mekano]

Every time i start zenarmor engine, my system is unusable because de CPU goes to 100% usage. Zenarmor is configure to don't start at boot so when this happens i reboot the computer to make it accessible again. I have a protectli VP2420 with 16 gig of ram. Everything was working fine before that.

I don't know why this is happening. Anyone in the same situation ?

[Seimus]

Hello,

What deployment you are using, driver, interfaces, DB, etc. ?
Did you check top output?

If its ZA doing this,
Best to contact ZA support directly via a ticket using the UI.


Regards,
S.

[notspam]

Protectli VP2420 with 16 GB of RAM ......

Intel Celeron J6412
* Quad Core
* 1,5 MB L2-Cache
* 2,0 GHz with burst till 2,6 GHz
* Intel AES-NI hardware acceleration

is really fast enough.
A mismatch with suricata on the same interface ?

100% is in top viewed on cli?
And which are the processes using the whole cpu cores ?

Zenarmor free edition can only use 1 cpu core.