New Source NAT page

[Ted]

Greetings,
I have an OPNsense box running 26.7.2_2-amd64. The WAN interface has a static /29 subnet. Some IPs are used for specific servers. In previous versions of OPNsense, I used Outbound NAT to direct internal servers to a specific external address.

When I upgraded to 26.7, I decided to migrate the Outbound NAT rules using the steps outlined under the Migration assistant. I downloaded the Outbound rules, looked over the CSV file, and then uploaded the CSV file. I tested from an external network, and everything appeared to be working. I went to look at the new Source NAT page, and the page claimed to be "showing 1 to 4 of 4 entries", which sounded right. However, no entries were actually displayed.

I decided that it should not cause a problem if I manually added the rules. (If it did, I could always delete them). Again, I tested the servers from an external network, and everything appeared to be working. I went back to look at the new Source NAT page, and the page claimed to be "showing 1 to 8 of 8 entries", which sounded like I had managed to double up on my rules. However, this time, 4 entries were displayed (most likely the ones I added manually).

This doesn't seem to be causing a functional problem, and I'm inclined to leave it alone lest I break something. Do I really have eight rules? If necessary I can SSH in and edit a config file. Is the wrong count displayed? In that case I can learn to ignore it.

Grateful for any suggestions on this.
Thanks,
Ted

[Monviech (Cedrik)]

Can you share what you have configured in /conf/config.xml (your config backup) for these Source NAT rules?

Also what is your NAT mode?