Home
Help
Search
Login
Register
OPNsense Forum
»
English Forums
»
24.7 Production Series
»
bandwidth limiting on pipes seems to work for roughly 10 minutes.
« previous
next »
Print
Pages: [
1
]
Author
Topic: bandwidth limiting on pipes seems to work for roughly 10 minutes. (Read 293 times)
frankr2994
Newbie
Posts: 3
Karma: 0
bandwidth limiting on pipes seems to work for roughly 10 minutes.
«
on:
September 02, 2024, 05:12:17 am »
Ok so i've been running opnsense for a bit now without issue. Been working great up until last night. I do alot of VR gaming and noticed alot of lag. Started looking at numbers and I was getting some big latency. I have gig. internet and had a couple pipes setup to bring those numbers down. Apparently not working anymore. So I re-did the settings. Worked again. 10 minutes later I had full speed and big latency. Messed around with it for a bit and decided to update. So now I'm on the latest version. Same thing is happening. I have set pipes and rules up for a specific IP address and for it to be network wide. Either way when it works it does what I need it to do. Only seems to work for 10 minutes or so. In the UI I see no indication that it has stopped working though. These are the settings I currently have. And they did work just fine for a little while just like any of the other settings I've tried.
Logged
frankr2994
Newbie
Posts: 3
Karma: 0
Re: bandwidth limiting on pipes seems to work for roughly 10 minutes.
«
Reply #1 on:
September 03, 2024, 11:37:35 am »
Playing around with this it seems that almost any setting changed anywhere in opnsense let's this function again for about 10 minutes. There is something definitely timing out with the traffic shaper.
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
English Forums
»
24.7 Production Series
»
bandwidth limiting on pipes seems to work for roughly 10 minutes.