php exited on signal 10 (core dumped) after upgrade to 24.7

[TheGrandWazoo]

Good day,

After upgrading 24.1.10_8 via the UI to 24.7 my firewall will not complete a full startup. I am getting the above subject line output when the system is starting up and then a "Enter full pathname of shell or RETURN for /bin/sh:". Typically this /bin/sh appears when "Launching the init system". Sometimes a "Bus error (core dumped)" follows the php core dump.

This was done on my secondary firewall. The primary is still running 24.1.10_8.

Tried to perform a "opnsense-update" from the command line but receive a "Mirror read failed" most likely due to the system not getting the proper configuration.

Any clues, except a reinstall, on what might be wrong?

[TheGrandWazoo]

Ok, I guess I will reinstall.