Home
Help
Search
Login
Register
OPNsense Forum
»
English Forums
»
24.1 Legacy Series
»
Automatic outbound NAT rule not populating
« previous
next »
Print
Pages: [
1
]
Author
Topic: Automatic outbound NAT rule not populating (Read 363 times)
cyrus104
Newbie
Posts: 39
Karma: 1
Automatic outbound NAT rule not populating
«
on:
May 27, 2024, 03:42:04 pm »
I have a new OPNsense setup and have the lan and wan side configured. The lan side is providing dhcp configured correctly. The wan is fios that is pulling an ip and default route. The opnsense can ping Google and raw up addresses. An automatic gateway was setup and monitoring to 1.1.1.1 with great latency.
The issue is that it doesn’t matter what I have set in outbound nat no automatic entries are created. I’ve tried to find the logs for that but haven’t had any luck. I see a manual entry right now but would like to change it. I’ve done some searching and made sure options like upstream gateway are checked. The gateway says default in the rules.
I’m sure it’s something simple but happy to look through the logs if you can point me to the ones that would have relevant information on creating or not the automatic or hybrid rules.
Thanks
Logged
cyrus104
Newbie
Posts: 39
Karma: 1
Re: Automatic outbound NAT rule not populating
«
Reply #1 on:
June 02, 2024, 05:02:04 pm »
Would like to see if this is a common issue.
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
English Forums
»
24.1 Legacy Series
»
Automatic outbound NAT rule not populating