Reverting to 23.1 from 23.1.6 Fixed My Problems

[Bluewind]

Yesterday I posted this article in the 23.1 Production Series Forum:

Problems w/23.1_6 Upgrade including IPv6 - Maybe a Zenarmor Issue?

After removing Zenarmor, my system crap to not great. CPU and memory usage were significantly higher than normal. Better but not normal.

I had the 23.1 image so I did a fresh 23.1 install with the last 23.1 config that I backed up.

After the fresh install WITHOUT ANY PLUGINs running, the CPU and memory returned to normal. IPv6 is working fine. CPU usage is 1%. Memory is around 20% and is steady. Thermal sensors never leave the green/low temp.

My plugins that I normally run are UPNP, Zenarmor, and ACME client. I am going to leave them off for a few days pending questions from Franco or others.