Local vs Remote confusion

[nijezauzeto]

Hi,

Actually, the passive mode is using pcap, not netmap. the disadvantage of it is that you lose blocking features. @GeoffW, I will get back to you on Monday about the passive mode issue.

Hi @sy

Any updates on this by any chance? I have the same issue (in all modes, not just passive), and I have also made sure that WAN traffic is not passing through the Zenarmor-protected interface as is mentioned in the troubleshooting . However, all remote hosts/IPs are shown as local in the charts, while my local hosts are shown as remote, which makes heat maps completely useless too.

I am running OPNSense 23.7.6 with Zenarmor engine 1.15.1.

Thanks!

[sy]

Hi,

Please share a report by following the instruction in the below link.

https://www.zenarmor.com/docs/support/reporting-bug

[wstemb]

https://forum.opnsense.org/index.php?topic=33270.msg160924#msg160924

Graphs were reverted, but the drill down filters  were working only if manually changed in right (expected, not offered) way.

Since the issue was visible only in passive mode and  disappeared using routed mode, I did not work on it last months. 

Have to check if it is still present in the new versions/releases of Zenarmor.