OPNsense
  • Home
  • Help
  • Search
  • Login
  • Register

  • OPNsense Forum »
  • Archive »
  • 22.7 Legacy Series »
  • no connection with 22.7, fine with 22.1
« previous next »
  • Print
Pages: [1]

Author Topic: no connection with 22.7, fine with 22.1  (Read 540 times)

csutcliff

  • Newbie
  • *
  • Posts: 5
  • Karma: 1
    • View Profile
no connection with 22.7, fine with 22.1
« on: September 12, 2022, 12:03:12 pm »
Hi,

I run a couple of opnsense installs in a datacentre where the provider requires that the WAN interface is set to 100baseTX Full-Duplex. Autonegotiation is not supported. This has been working fine since I switched from pfSense a few years back. The interfaces in question are I350-AM4 (igb) built into Supermicro M11SDV-4CT-LN4F.

With 22.7 I have no connection and ifconfig reports "status: no carrier" on these interfaces.

In my troubleshooting if I select autonegotiation (albeit unsupported by the provider) it defaults to 100baseTX half-duplex which sort of works but has many errors and collisions.

Downgrading to 22.1 restores normal functionalilty.
« Last Edit: September 12, 2022, 01:45:09 pm by csutcliff »
Logged

lilsense

  • Hero Member
  • *****
  • Posts: 526
  • Karma: 19
    • View Profile
Re: no connection with 22.7, fine with 22.1
« Reply #1 on: September 12, 2022, 02:42:58 pm »
what commands do you set to go back and forth between auto/full
Logged

csutcliff

  • Newbie
  • *
  • Posts: 5
  • Karma: 1
    • View Profile
Re: no connection with 22.7, fine with 22.1
« Reply #2 on: September 12, 2022, 03:44:06 pm »
Code: [Select]
ifconfig igb0 media 100baseTX sets half duplex ("works" but with errors)

Code: [Select]
ifconfig igb0 media 100baseTX mediaopt full-duplex sets full duplex (no carrier)

I tried autoselect from the opnsense webgui when it was already at half-duplex
Logged

lilsense

  • Hero Member
  • *****
  • Posts: 526
  • Karma: 19
    • View Profile
Re: no connection with 22.7, fine with 22.1
« Reply #3 on: September 12, 2022, 04:27:07 pm »
are you restarting the device/service when you switch to full duplex?
Logged

  • Print
Pages: [1]
« previous next »
  • OPNsense Forum »
  • Archive »
  • 22.7 Legacy Series »
  • no connection with 22.7, fine with 22.1
 

OPNsense is an OSS project © Deciso B.V. 2015 - 2023 All rights reserved
  • SMF 2.0.19 | SMF © 2021, Simple Machines
    Privacy Policy
    | XHTML | RSS | WAP2