VLAN tagging on Protectli Opnsense Box with Netgear smart switch

[cpaetz]

I had my network set up with a Ubiquiti Edge Router lite with 2 additional VLANS connected to a Netgear smart switch and everything was working great. I tried to swap out my Edge Router Lite tonight for an Opnsense Protectli box, and now none of my VLANS seem to be working, all the devices are getting DHCP addresses from the main network on VLAN1.

I am outputitng my main network on igb1 on VLAN 1, and a guest network and a IoT network on VLANS 111 and 112 trunked over the same igb1 port to the switch. My PVID's are all set to 1 for all ports, and VLAN 111 and 112 are tagged on all ports. The switch configuration has not been modified since swapping the edge router out, and if I put the edge router back in, everything goes back to normal and works properly again.

Can anyone point me in the right direction? This is my first shot at Opnsense.

[lilsense]

did you check the firewall for the vlans.