[SOLVED] Bug? - VPN: IPsec: Tunnel Settings not displaying more than 1 Phase 2

[Nick-YourIoT]

I am using OPNsense to terminate multiple aggressive IPsec IKE v1 tunnels from legacy devices connected on dynamic IP addresses.

Each device has a unique phase 1 (password) and phase 2 (remote subnet) entry.  Previously (21.7) they were paired in the GUI with each phase 2 listed under the unique phase 1.

Since 22.1, the phase 1 and phase 2 are separated, however, there is a bug where the (25 entries in my case) phase 1 entries are shown but only 1 of the matching 25 x phase 2 entries are shown.

If I look in the backup XML I can see all the 25 x phase 2 entries correctly.

Is there a way to roll back the interface to the older style?

Is this a bug?

[TheHesster]

The way it's shown changed. Now it only shows the Phase 2 entries for the phase 1 entries that are selected with the check boxes to the left of the phase 1 entries.
Check off a couple different ones and you can see the phase 2 entries for those! 

[Nick-YourIoT]

Thank you!

What a horrible way to work through remote IP networks but they are all there.

You're a star!