ZFS with Freeradius no Auth-Type found

[MiRei]

When I install OPNSense 22.1.2 or 22.1.3 with ZFS, I reproducibly get the following error.
After restoring the backup authentication wit freeradius on Unifi APs no longer works.
The LOG of the radius server says:

Auth: (136) Login incorrect (No Auth-Type found: rejecting the user via Post-Auth-Type = Reject):

If I reinstall the system under vfs, the authentication works. The behaviour is identical on two completely different systems.

Does anyone have any ideas?

MiRei

[wallaby501]

I can't confirm as I didn't much use it before with my old system (on 21.x) but I'm using 22.1.2_1 with ZFS and see the same error when trying to authenticate. I couldn't authenticate over openvpn so I went back to basics, made sure freeradius is set and configured and used System-Access-Tester and still get this same error.

[mimugmail]

I can't confirm as I didn't much use it before with my old system (on 21.x) but I'm using 22.1.2_1 with ZFS and see the same error when trying to authenticate. I couldn't authenticate over openvpn so I went back to basics, made sure freeradius is set and configured and used System-Access-Tester and still get this same error.

For you 22.1.3 should do it, I dont use zfs, No idea whats wrong over there

[wallaby501]

I can't confirm as I didn't much use it before with my old system (on 21.x) but I'm using 22.1.2_1 with ZFS and see the same error when trying to authenticate. I couldn't authenticate over openvpn so I went back to basics, made sure freeradius is set and configured and used System-Access-Tester and still get this same error.

For you 22.1.3 should do it, I dont use zfs, No idea whats wrong over there

Well, I've been doing a little swapping between my backup firewall and my normal one and the one on 22.1.4_1 is now working just fine authenticating via freeradius. No config changed between it all so must have just been a bug on that version or something.
Thanks!