[SOLVED] IPSec VPN - Tunnel Settings Phase 2 add entry button missing

[Chaskel]

Hello,

I am not sure if the following process created the situation I am facing, or if this is being seen by default:

- I installed 22.1.1_3 today on new hardware and imported a config file from my previous system.
- I disabled the one existing IPSec Tunnel Settings Phase 1 and Phase 2 rows I had.
- I cloned the one existing Phase 1 row I had.
- I cloned the one existing Phase 2 row I had.
- After making changes to the cloned Phase 1 and Phase 2 rows and enabling them, I clicked on checkbox to the left of the Phase 1 section "Enabled" checkbox for both the original and cloned row and noticed that the cloned Phase 2 entry was associated with the original Phase 1 entry and not the cloned one.
- At this point I could not see any "add" button to add a Phase 2 entry.
- I then deleted all Phase 1 and Phase 2 entries to and created a new Phase 1 entry.
- I am still not seeing an "add" button to create a Phase 2 entry. (image attached)

I am not sure if the steps I reference above created the problem, or if the add button in the Phase 2 entry is missing?

Any assistance would be greatly appreciated.

Thank you.

[8191]

Hi
The add P2 button is actually located next to the corresponding P1 entry.

[Chaskel]

Oh deary me. Thank you so much and I can't believe I missed that. It's been a long time since I've been on that screen and I appreciate your help.

Take care

[8191]

I think the user interface can really be improved here, as such exceptions from the rule are really counterintuitive.