Bell Fiber - Can't configure PPPoE

[Hendo9000]

I'm a newb. I have a Bell modem in passthrough. I know my credentials work. Bell has verified, and I was using Sophos previously. I'm literally just trying to get OPNsense to pull an address from Bell.

I don't think I need VLAN tagging, because I'm not trying to use any new hardware, just passing through to OPNsense.

I can't ping anything, I can't seem to connect at all.

[thogru]

Hi Hendo,

Please find attached the settings of my PPPoE device. I think the main difference is your "Bell" entry in the "Service name" field.

I can confirm that your OPNsense was not connected. If connection work, you will see some IP addresses (IPv4 and IPv6 as well) in the PPP-log.

Kind Regards
Thomas