Author Topic: Installer hangs at "Select Task" on Hyper-V Generation 2 VM (Read 33843 times)

marjohn56 · « **Reply #15 on:** January 15, 2019, 08:03:01 am »

Can you try the image Franco has supplied in message #10.

bimmerdriver · « **Reply #16 on:** January 16, 2019, 05:08:42 am »

I tried a clean install (new vm) using the image from message #10. The installer hung at guided installation. I interrupted with CTRL-C, then logged in again as installer. The installer started from the beginning and hung again at guided installation. The same cycle repeated again, but the next time, login was not successful. It was dead in the water.

mts · « **Reply #17 on:** February 24, 2019, 08:09:34 pm »

Hi guys.

I have exactly the same problem but I‘m not even installing on a virtual machine.
I have a clean and brand new hardware here. As soon as I‘m reaching the guided installation the installer hangs.

mts · « **Reply #18 on:** February 24, 2019, 08:33:23 pm »

I could manage to install if by booting in legacy mode, not uefi.

igpit · « **Reply #19 on:** December 16, 2019, 12:39:28 am »

I just had the same issue (+solution) with opnsense 19.7 as reported by bimmerdriver. Hang when shown "Guided Installation". Ctrl-C and retrying solved it.

Running on Win10 1909 Hyper-V, Gen 2 VM.

Author Topic: Installer hangs at "Select Task" on Hyper-V Generation 2 VM (Read 33843 times)

marjohn56

Re: Installer hangs at "Select Task" on Hyper-V Generation 2 VM

bimmerdriver

Re: Installer hangs at "Select Task" on Hyper-V Generation 2 VM

mts

Re: Installer hangs at "Select Task" on Hyper-V Generation 2 VM

mts

Re: Installer hangs at "Select Task" on Hyper-V Generation 2 VM

igpit

Re: Installer hangs at "Select Task" on Hyper-V Generation 2 VM