Enabling Webgui on WAN from CLI?

« previous next »

Print

Pages: [1]

Author Topic: Enabling Webgui on WAN from CLI? (Read 10330 times)

heinzelrumpel

Newbie
Posts: 11
Karma: 0

Enabling Webgui on WAN from CLI?

« on: September 02, 2018, 12:22:50 pm »

Hi,

is it possible, to enable Webgui on WAN interface from the cli? Problem ist, that I installed on a Hyper-V test environment and WAN ist the only reachable interface right now.

Logged

fabian

Hero Member
Posts: 2769
Karma: 200
OPNsense Contributor (Language, VPN, Proxy, etc.)

Re: Enabling Webgui on WAN from CLI?

« Reply #1 on: September 02, 2018, 12:25:30 pm »

It is very likely that the only resonable way to do it is disabling the packet filter temporary (pfctl -d) and then fix the configuration or if it is IP related, you should be able to configure it via the menu (IP, subnet, DHCP)

Logged

heinzelrumpel

Newbie
Posts: 11
Karma: 0

Re: Enabling Webgui on WAN from CLI?

« Reply #2 on: September 02, 2018, 12:58:32 pm »

OK, I found this article https://github.com/opnsense/core/issues/141. I followed the procedure, even did pfctl -d, but I cant reach webgui via wan. WAN is getting ip from dhcp but even on shell I cannot ping the dhcp server. I really dont know what is going wrong.

Logged

fabian

Hero Member
Posts: 2769
Karma: 200
OPNsense Contributor (Language, VPN, Proxy, etc.)

Re: Enabling Webgui on WAN from CLI?

« Reply #3 on: September 02, 2018, 02:51:54 pm »

Does the DHCP server respond to pings from other machines as some machines are (mis-)configured to block it? Is it in the neighbor cache (arp, ndp)?

Logged

Print

Pages: [1]

« previous next »