OPNSense gets IPV6 but not on boot.

[TeeJayD]

Facing a very strange issue where ipv6 works but everytime opnsense starts, I need to manually go to the wan interface and just save without changing anything. Otherwise it'll just not get ipv6 on the WAN interface and consequently, on all others.

https://imgur.com/a/jD73pc9 Config and interface overview

[TeeJayD]

Any ideas ?

[franco]

Of course, it's always PPPoE... Been working on similar cases in the past but haven't been able to find a solution that fits all. Some ISPs don't like the timing of the booting sequence, leading some ISPs to reconnect a few times with different IPv6 results (IPv6 connected yes/no/sometimes).


Cheers,
Franco

[TeeJayD]

Is there a way to trigger a "save and apply" on an interface without changing anything via command line? Since that's all that i need to do get an ipv6, i believe that would be enough to mitigate.