Tailscale new exit-node feature. How to use it?

[vamp]

Tailscale plugin latest release are support to use a other peer to exit-node. The release note say that not enought to enable it, it need some firewall / NAT settings. I try to configure it, but not Work... my goal to my full subnet use mullvad exit-node to access the internet.

My exit-node a mullvad Endpoint . (I bought the Tailscale mullvad plugin)

[vamp]

So far that i set it up:

Create a new Gateway (set the opnsense tailscale IP address)




Add these rule to LAN




Add these rule to Tailscale0




Add hybrid NAT: Outbound

[Ben S]

It's been a while since I set this up and tested it but I think the gateway IP should be the remote exit node's Tailnet IP, not the OPNsense Tailnet IP.

[vamp]

Also try it, but not working... Seems it will be work a "normal" Exit-node, but not the Mullvad...