Dashboard Gateways widget only shows four gateway addresses

[kick3074]

I have three ISPs plugged into WAN, OPT1 and OPT2 respectively (on a Protectli Vault). Each has a functioning IPv4 and IPv6 address.

My 24.7.6 dashboard only shows WAN_DHCP4, WAN_DHCP6, OPT1_DHCP6, OPT2_DHCP6.

OPT1_DHCP4 and OPT2_DHCP4 are always missing.

I unplugged my WAN cable, and I still only see the usual connections. Any ideas?

[franco]

Can you show a screenshot of your gateway configuration? I suspect the IPv4 ones were never saved so they are "automatic" which means the widget may not see them (you can tell by the absence of the trash can icon in the gateway configuration).


Cheers,
Franco

[kick3074]

Hi Franco,

Thanks for responding. Attached is the screenshot.

[franco]

And this corresponds exactly with the previous screenshot? Because this one looks like the dashboard widget would look different.


Cheers,
Franco

[kick3074]

Yes. Same configuration. Same time. Attached is a new screen shot of two views of opnsense (in two separate browser instances - the right one overlapping the left one).

[kick3074]

I'm unofficially closing this thread because the problem has mysteriously gone away. I can now see all six of my gateways (3 IPv4 and 3 IPv6).

I don't know when or how I "fixed" it, but the two missing IPv4 gateways may have reappeared after I added a few additional VLANs. But, I'm not at all sure that was what did it.

I know the correction wasn't fixed due to upgrading from 2.7.6 to 2.7.7.