Zenarmor 1.14 - Unable to select multiple protect interfaces in global config

[db9]

I upgraded Zenarmor from 1.13 to 1.14. After that the Zenarmor dashboard gave me network errors, but I can bypass that issue by connection to the management IP-address in stead of FQDN

The issue that I facing now is that I cannot select multiple interfaces to protect in the global Zenarmor configuration. After selecting multiple interfaces (and define security zone), then I press apply, Zenarmor confirms the change, but after reloading the page only one interfaces is selected. In the dasboard view two interfaces are shown in the graph as enabled, but they are different from the global config. I am using the default policy.

I some case I was able to select 2 but never more then 3.

[sy]

Hi,

Thanks for the feedback. Both issue is fixed and a patch release will be shipped today.

[db9]

After installing version 1.14.1 the two issues I mentioned are solved.

New issue (I think) - I have selected 4 interfaces to protect. The Traffic Graph (Throughput) in the dashboard view does not show any volume/packets graphs. With the upgrade to 1.14 the graphs where visible (2 interfaces), with 1.14.1 no graphs after a couple of minutes.