Fitlet2 fresh install: Segfault using vga. Installed via SSH and worked.

[typoman]

This is just an FYI for anyone who runs into this issue.

I got the a segmentation fault error doing a clean install of 20.1 on a J3455 Fitlet2.  The error appears when I hit "Accept these settings" at the very beginning of the graphical installer. 

This was while using a directly attached monitor and keyboard.  I did some research and found this article which pointed me in the direction of the root cause having something to do with integrated graphics.  The command in that article doesn't do anything.  I then found somewhere else, I think on this forum, that I can bypass this error by installing via SSH. 

I booted from the USB stick and assigned interfaces and IP to the LAN.  I was able to SSH in and successfully run the installer that way.

I had been running OPNSense on this hardware for years and doing in-place upgrades without a hitch, including all the way to 20.1.8.  I did a ton of experimentation without saving my good config so I just wanted to start fresh with a clean build. 

Just a reminder for Fitlet2 users, update to the latest BIOS and disable all 3 SCC components in the South Bridge settings.