Change of gateway settings after 19.1 series, problem setting up new settings

[Rayman]

Hi,

I've tried upgrading before from 19.1 series on my A10 appliance, but it always failed because internet was no longer working from the LAN.

I first noticed (on 20.1) that the default route was pointing to my WAN_IPTV interface which of course will not work.

Then I started plaing around with the gateway settings.

I have attached my old and new gateway settings.

In 20.1 I have disabled my WAN_IPTV gateway, making the default route 'normal' and internet working.

Despite disabling the WAN_IPTV gateway, the IPTV appears to be working fine. EDIT: After 2 days the IPTV receiver will not start anymore, so it's not fine after all.

I just can't help wondering that this setup is not the setup it should be. What do you think the correct settings would be?

My setup: Xs4all fiber connection with internet on VLAN6 (PPPoE) and IPTV on VLAN4.

In gateway, logs, I find lots of the following errors:
dpinger: WAN_INTERNET_DHCP6 fe80::xxxxxx%pppoe1: sendto error: 65

IPv4 + IPV6 internet are working normal.

[Rayman]

Edit: Post completely modified.

At first I focused only on the default route, which is changed by default gateway.

I still hope that someone can help me to set this up correctly, as I'm not convinced it's right this way (in the old setup the WAN_IPTV gateway was not disabled).

EDIT: It turned out that the IPTV receiver will not boot again after 2 days working fine. So the setup still needs adjusting.

Thanks!


Kind regards,
Raymond