OpenVPN "Force all client generated traffic through the tunnel." IPv4 only

[netgeek]

I'm running OpenVPN on 20.1-RC1.  I select "Force all client generated traffic through the tunnel" in my OpenVPN Remote Access server config.  I use the client export utility.  I can connect fine from my laptop, and I get assigned a working IPv4 and IPv6 address.  However, only the 0.0.0.0/1 and 128.0.0.0/1 routes through the VPN tunnel are added when I connect.  No IPv6 routing table entries are made, and none of my IPv6 traffic goes over the VPN.   Shouldn't ::/1 and 8000::/1 routes be added when I connect?  If I manually add the routes on my laptop, it can access the internet fine over the IPv6 OpenVPN link, but by default, no IPv6 traffic goes over the tunnel.

[bartjsmit]

Not sure if it is the same with 20.1-RC1 (I'm not brave enough) but on 19.7 I've added this option under 'Advanced' in my OpenVPN server:

push "route-ipv6 2000::/3"

This allows the clients to access public IPv6 addresses through the tunnel. You can add any ULA ranges that you have on the server end, if required.

Bart...