wrong interface after upgrade

[manustar]

I don't know if it's a coincidence, but I updated from GUI to version 26.1_4, and after about 30 minutes of not being able to connect, I went directly to the physical firewall and saw that it changed the order of the interfaces, which consequently disabled the various VLANs. I gradually fixed it and flagged prevert remove, also because this interface problem occurred even after I fixed it and restarted the fw.

[franco]

So the question is which volatile network device/tunnel did you assign as an interface?


Cheers,
Franco

[manustar]

The problem was that it reversed the assignments of the physical interfaces, my configuration is igb0 WAN and igb1 LAN and all the vlans are parents of igb1. The strange thing is that I reassigned the interfaces, reset the vlans (it didn't delete them but only unassigned them) and when I rebooted I found igb0 LAN igb1 WAN

[franco]

... which only happens when you assign an interface that moves it's location upon reboot or is not there during early boot?


Cheers,
Franco