Update to 24.7.2 failed

[gillbot]

I just updated to 24.7.2 via GUI and everything seemed ok, but all routing stopped shortly thereafter. Tried accessing via GUI but nothing seemed to be running so I hooked up a screen to the system. (Mini-pc with quad 2.5GBe)

It was asking me to mount a file system in the CLI so I rebooted only for it to stop on the same line. It scrolled too fast but I did observe a panic somewhere in there, not sure how relevant that is

After some messing, I figured out how to select an old kernel in the CLI and it would run and let me into the GUI. Unfortunately this is all the further it would go as dhcp didn't seem to work. All dhcp clients were disconnected with no ip and all static ip's had no internet access. When I made any changes and hit apply, they didn't seem to stick, then if needed, every reboot would revert back to the newer kernel and ask for a file system mount so I'd have to revert to an old one temporarily.

I finally just gave up and reinstalled everything but once again, no dhcp. After more issues, I tried reinstalling again only for it not to detect LAN. Third try same issue with detecting LAN but on the fourth, it came back online. I've left it there for now. I had a configuration backup but I'm nervous to try and load it so I plan to leave it as is for now and worry about my settings later. Two angry teenagers and a wife with no internet for much of a Saturday isn't worth it.

[doktornotor]

After a panic, nothing will work. It will just reboot. Without that info it's impossible to advise.

[Patrick M. Hausen]

In the single user shell try

fsck -y

[gillbot]

In the single user shell try

fsck -y

Nothing left to try, I already wiped out and reinstalled from scratch. Took four retries but it finally got going again. I didn't have any issues on my first install but that was forever ago, no idea what version I initially started from.

[Patrick M. Hausen]

Did you install with ZFS now? Highly recommended for exactly the reason you experienced.

[gillbot]

Did you install with ZFS now? Highly recommended for exactly the reason you experienced.

I'd have to re-run through the steps to confirm, I honestly have no idea. I just used defaults and keyed through.

[newsense]

This command will show you where you are:

Code Select Expand

df -hT |grep root

[gillbot]

They all say zfs

[newsense]

So what's the current status and patch level. What is the output if you try to upgrade from CLI ?

[gillbot]

So what's the current status and patch level. What is the output if you try to upgrade from CLI ?

Fresh install using 24.7 updated fine from GUI to 24.7.2. I didn't have a lot of crazy extra settings so not too much was lost, but still isn't fun starting from scratch especially since I don't remember what all settings I've changed.

[newsense]

Downloading the config before an upgrade is not hard to do.

Also, starting with 24.7.3 snapshots will be available on ZFS installs. You can practice on a VM to get acquainted with the process, both from GUI and CLI.

[franco]

Promised to take a look here. It sounds a little like the agp issue, but nothing to confirm.

If you have 24.7 running please do a quick:

# dmesg | grep agp

That being said it should be solved once 24.7.3 hits later this week if it's really this one. If not we will need a panic string indeed.


Thanks,
Franco

[gillbot]

Either i'm doing something wrong or not sure, but when I enter that command, nothing happens.

[chemlud]

Nothing wrong, only no "agp" in your dmesg output... :-)

[doktornotor]

Which is a good thing. 😉