System >> Routes failing after reboot

[Seimus]

So you have same /24 subnet on two different Routers/OPnsense boxes?


What I was asking is if the GW used for this static is the WG interface on the OPNsense of the otherside. And if when the route is not installed if there is a route & ARP entry visible towards that GW itself.

Because as I was talking about recursive lookup, there should be at least 3 routes.
1. The static route one for Destination 192.168.100.100 pointing over interface WG & Gateway set for static
2. A route showing how to reach the Gateway
3. A route showing which interface is the egress for this GW

Regards,
S.