Clients cannot got IPv6 address when I use ZenUK

[ylu]

I set the wan with dhcpv6 and lan tracker interface(wan) by referring to https://docs.opnsense.org/manual/how-tos/IPv6_ZenUK.html .The only difference is that I didn't check 'Use IPv4 connectivity' because I didn't use PPP connectivity link.
The iuuse is I can got a wan ipv6 address but the clients bebind lan cannot got any IPv6 address...
I also tried set lan with static  ipv6 address, then I cann't Ping [2001:4860:4860::8888] from lan(wan works fine).

[Taunt9930]

If you set it up as per the second section - use static assignment, then it works (taking care to use the right addresses - some of the screenshots are using the old guide, that has a different prefix). You do also need to tick the Use IPv4 connectivity, as the IPv6 traffic does use the PPPoE link. Have you set up the router advertisements?

I have found that using DHCPv6 tracking the WAN interface is unreliable.

If you're not using PPP, then what are you using? Zen is PPPoE.

[ylu]

I got wan ipv6 address by dhcpv6 from IPS.

[Taunt9930]

IPS?

With Zen you need to tick use IPv4 connectivity. If your OPNsense appliance is behind another device then we need more info, but I suspect you will have issues unless it is in bridge mode.