MultiWAN: Access explicity to network of WAN2

[floh]

Hello I just set up MultiWAN Group with WAN as Tier1 and WAN2 as Tier2 and defined monitoring for both interfaces. I also changed the Gateway to MultiWAN Group for the rule for LAN.

I'm still online, and everything is fine (over WAN). Currently WAN2 is not online yet (its new and a technician is on the way here, to set up the phone line). Well, I'd like to access the Router of WAN2, so I can setup it from LAN network. OPNsense is able to ping the router connected at WAN2.

But I'm routed to WAN instead to WAN2 from LAN. I found out this with the help of traceroute:

Code Select Expand

traceroute 192.168.188.1
traceroute to 192.168.188.1 (192.168.188.1), 64 hops max, 52 byte packets
1  opnsense (192.168.100.1)  0.792 ms  0.165 ms  0.153 ms
2  fritz.box (192.168.178.1)  1.336 ms  0.727 ms  1.388 ms
There you see, the traceroute went to 192.168.178.1 which is WAN.
WAN = 192.168.178.1/24
WAN2 = 192.168.188.1/24

I'd expect, if I use destination address which is in network range of WAN2, then opensense would route to WAN2 no matter if the gateway of WAN2 is down.

Best regards
Floh

[floh]

Hi everybody.

So no idea yet? I've set up 2 routes:

• 192.168.178.1/24 to WAN
• 192.168.188.1/24 to WAN2

But still only one of both Gateway is accesible so the route setting didn't help.

Really nobody with an idea? Or is this a missing feature of OPNSense?

Best regards
Floh