OPNsense 21.1.4-amd64 -- igmpproxy wan't start

[UliS]

Hello Forum,

I have installed OPNsense and the plugin igmpporxy, an up and down stream interface with indication of the networks is configured. The interfaces are activated and yet the igmpproxy does not start. I found an old thread for a version 18.x, but it is not up to date.

Here is the error message:
2021-04-18T19:20:31 igmpproxy[12823] Sender VIF was down.; Errno(50): Network is down

Here are the content of /usr/local/etc/igmpproxy.conf:
##------------------------------------------------------
## Enable Quickleave mode (Sends Leave instantly)
##------------------------------------------------------
quickleave
phyint igb0 upstream ratelimit 0 threshold 1
altnet 87.141.0.0/16
altnet 232.0.0.0/8

phyint igb2 downstream ratelimit 0 threshold 1
altnet 192.168.2.0/24

phyint igb1 disabled
phyint igb3 disabled

Regards,
UliS

[UliS]

Hello Forum,

I was done some investigatons and figure out that igmpporxy will start when the NIC has the status active. I have a 6 NIC device and use a dedicated NIC for the Telekom MR 401, which is most of the time switched off. In this case igmpproxy wan't start, on pfsense igmpproxy starts even if the NIC has no carrier. For my point of view there is a little bug, where can I report this issue?

Regards,
UliS