Stuck at splash screen

[TREYKOV]

Good afternoon friends,

OS: 20.7.1

Problem: Is need to press ENTER to load the operating system.

Once ENTER is pressed, the system loads correctly.

What should I do to enable the system to boot automatically and unattended?

Thanks in advance.

[mimugmail]

Screenshots?

[TREYKOV]

Thanks for answering!

Pressing ENTER on this screen the OS starts up without problems and everything works normally!

The point is: avoid having to hit enter to start the firewall!

I suspect this fault was caused by a power outage!

Any ideas?

[mimugmail]

I guess something filesystem or hdd error. Can you reinstall and restore a backup?

[TREYKOV]

I have backup of the configuration, but not of the OSS.

Execute the command "fsck -y /" and it says that everything is fine with the FS!

Do you have any suggestions to run a diagnostic on the HDD?

I am not in the place where the hardware is.

Is possible to remotely run an OSS reinstall?

Thanks

[littlepepper]

Unless your computer has a Remote Management card it is pretty hard to reinstall the OS remotely.

Have you change the settings in /boot/loader.* files? that's where the autoboot timer setting is located.

[TREYKOV]

I do not have a remote management card. 

I haven't changed anything, this was working properly until the power outage.

Any suggestions to check if the /boot/loader.* file is OK?

[littlepepper]

look under stage 3 in here https://www.freebsd.org/doc/handbook/boot-introduction.html