Help on VXLAN Configuration

[Tcoda]

Hi, guys,

We hope you can support us in setting up VXLAN

We have the following scenario:
We have a location (side A) with an Opennebula cluster including Fujitsu PSwitch for the network and a location (side B) with a Fujitsu Pswitch and two compute nodes from the Opennebula cluster.

Between the two locations there is the OPNsense on side A and behind it several Cisco switches which are managed by another data center administration. 
On the externally administered connection we get an access vlan 71.

In the Opennebua cluster there will be productive X amount of VLan networks.
Our goal is to connect side A and side B in such a way that both locations become logically one.

We wanted to use Q-in-Q first, but this is no longer supported in the latest OPNsense version.
Now we want to try our luck with VXLAN.

There are two physical interfaces, that are used as a bridge. This bridge has the ip-address 172.16.0.1/24, and is connected to the PSwitch. On this interface we created a vxlan  with the VNI 10, the Source-Address 172.16.0.1 and the Remote-Address 172.16.0.2 (PSwitch IP).
Next step was to create a vlan for the on this vxlan. This is used for the client-network-communication and has another network.

Is that the right configuration or do I have to assign new interface on the vxlan? Do I hav to assign me client-communication network on that interface, without creating a vlan or do I hav to do all steps?
Are there any documentation about vxlan in opnsense except docs.opnsense.org?

Many Thanks

[jackblack]

I have a similar configuration and I am also very interested in learning how to connect Opennebula VXLAN to OPNSense VXLAN. Anyone that can provide some guidance here?