Messages

I've now applied the patch and tried it again just by Enable & IPS mode, all without any rules enabled (just as the last time I tried). Unfortunate with the same outcome, NTP can't access network and DNS gets unstable. SO from my point of the same problem  :-\

In my effort to get IPS working again I've only downloaded only the default rules and disabled them. When Starting. Still, when starting NTP stops and DNS gets instable. I hope for 17.7.1

after endless testing/rebooting and when I was just about to rebuild is started to work even with "ntpd[35280]: mlockall(): Cannot allocate memory". Sorry I can't report what I did since I tried out so many things, now I just keep my fingers crossed.

Update. now I found it. By enabling IPS again it started to fail with the same pattern, NTP stops and Unbound started to get unstable. By disable IPS again, rebooting and all works again. What's wrong with the settings for IPS I don't know

no floating rules, or any dropped packages. It even looks like my WAN address goes out on port 123

Hi, After upgrading to 17.7 the NTP service is broken, please see attachment. It report that another process using the port but I can't find which. Also UnboundDNS is a bit shaky, it restarts from time to time. NTP say's Network is unreachable although the network is fully accessible. Firewall reports pass on all port 123, and it worked flawless in 17.1.

Any ideas what to try, I've tried all what comes to my mind.

cheers, tord

I'm a happy lad again, I've just tried 16.1 and it works great with my embedded Realtech NIC's :) At last I can use OPNsense, great stuff :) :)

I just tried to install 15.7.11_nano in a dual NIC MITAC. It all seems to work OK although boot takes a very long time (it just shows an underscore and waits or 3-4 minutes). I connect a LAN cable to re1 and I've assigned re1 to 192.168.1.2 (WAN is DHCP). If I go shell I can ping my own address but not any other computer on the domain :( I can see with ifconfig that re1 got the correct address and that it got status:active (which also the LEDs shows). No other computer on the domain can ping 192.168.1.2. Nor can I get contact with http(s)://192.168.1.2

I can't see any errors during boot. The NIC's are reattach :(

What's the issues here? ifconfig finds the NICs but I can't use them, what have I done wrong?

Update: Well it must be the HW that's not compatible with BSD :( It works great with smoothwall and clearos. So, I really wanted opnsense but my HW force me to use clearos.

bye bye

cheers