"
Hello.
I'm following this guide from the Tailscale KB to get OPNsense connected to my tailnet:
https://tailscale.com/docs/install/opnsense
I'm stuck on this part: https://tailscale.com/docs/install/opnsense#static-nat-port-mapping
It says to make these rules but I'm not seeing how I set source and destination ports to simply be "UDP" as I only see an option for setting a specific individual port or port range:
It also mentions an ACL change but I'm stumped on where I change that.
Any help would be greatly appreciated. Thank you! :)
I'm following this guide from the Tailscale KB to get OPNsense connected to my tailnet:
https://tailscale.com/docs/install/opnsense
I'm stuck on this part: https://tailscale.com/docs/install/opnsense#static-nat-port-mapping
It says to make these rules but I'm not seeing how I set source and destination ports to simply be "UDP" as I only see an option for setting a specific individual port or port range:
It also mentions an ACL change but I'm stumped on where I change that.
Any help would be greatly appreciated. Thank you! :)
