Messages

..

I thought after all these years I had plenty of knowledge until I attempted this installatoin of OPNSense Software on a PC.

If anyone can help I wouldbe greatful.  even would pay for help at this point.  Just impossibly massive failure.

this is where I am at.

• OPNSense Software/PC is installed and is getting out to Internet.
• One other PC connected to network, setup as dhcp unable to connect to internet.
• ISP is ATT Fiber, Managed Biz, dedicated, using a Silicom ATT-V150 Appliance managed by ATT, need to connect opnsense to this in order to get out to internet.
• Static IP Im trying to use is 12.132.133.165, rest of info below.
  WAN IP 12.132.133.160/29,
  WAN Gateway 12.132.133.161,
  WAN Subnet (CIDR)/29,
  Public Range (Begin) 12.132.133.162, Public Range (End) 12.132.133.166,
  Public Subnet Mask 255.255.255.248,
  Public Gateway 12.132.133.161,
  DNS 1 68.94.156.1,
  DNS 2 68.94.157.1.
  

Even after reading instructions and reearching for weeks I cant get this to work. I also dont understand the menu enough to figure out where some of this above metnioned info is supposed to go?  AI is useless as it jsut brings up old legacy menu tabs from many years ago.  I have had to reinstall 13 times.  So any help would be appreicated... 

Thanks