Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - atlassense

#1
Quote from: BrandyWine on October 10, 2026, 09:43:03 PMMy humble hypothesis.

Intel Management Engine (ME) in BIOS? If so make sure that's enabled.
Try flashing with the 2MB bin.

If that fails,
The Winbond is a SPI, and is likely write-blocking.
You could ask vendor for procedure to update i226 firmware, or venture down path on how to hack that SPI 8pin to allow flashing the i226.



I tried flashing it with the 2MB .bin file, but it threw an error. Everything points to it having a Winbond SPI chip with write protection :-(

The seller doesn't have any updates available.  I'll look into the possibility of hack the 8-pin SPI chip, though I think it'll be tricky.
#2
Quote from: BrandyWine on October 09, 2026, 12:18:31 AM
Quote from: atlassense on October 03, 2026, 09:13:59 AMyouyeetoo NIC M.2 to Gigabit Wired NIC, Intel i226 2.5G Ethernet Server NIC

Does the M2 side have a Winbond 25Q spi chip? If so what is that full chip number?


Hi BrandyWine,

In addition to the Intel chip (S5333L27 SRKTU), the M.2 section has another 8-pin chip with extremely small lettering. Using a magnifying glass, I managed to read the following:

2025WQ86 6
2540C
NÂș57669

According to Gemini, it is a Winbond 25Q.
Cheers.
#3
I have not been able to do the update.

NIC: i226-v M.2 A+E (youyeetoo NIC M.2 to Gigabit Wired NIC, Intel i226 2.5G Ethernet Server NIC, support M.2 B+M keys, M.2 A+E key, for youyeetoo)

The card is passthrough to OPNsense 26.7.4, virtualized in Proxmox VE 9.2.20.

I have tried from OPNsense, Proxmox, Debian-LXC-Live (with iomen=relaxed) and I have not been able to. Secure Boot disabled. Always error 6 with 'echo $?'

Log output:
Config file read.
Inventory
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Alternate MAC address is not set.
Flash inventory started.
Shadow RAM inventory started.
Shadow RAM inventory finished.
Flash inventory finished.
Update
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Creating backup images in directory: 022626022999.
Backup images created.
Flash update started.
Error: Flash update failed.
Device update failed.
Update security reviews
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Skipping update minimum security revisions.
Update VPD with VPD template
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Skipping VPD update with VPD template.

Inventory output:
./nvmupdate64e -i -c nvm.cfg -l out.log

Config file read.
Inventory
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Alternate MAC address is not set.
Flash inventory started.
Shadow RAM inventory started.
Shadow RAM inventory finished.
Flash inventory finished.
[00:001:00:00]: Intel(R) Ethernet Controller I226-V
Vendor: 8086
Device: 125C
Subvendor: 8086
Subdevice: 0000
Revision: 4
LAN MAC: 022626022999
MAC Alt: 000000000000
SAN MAC: 000000000000
ETrackId: 80000308
SerialNumber: 022626FFFF0xxxx
NVM Version: 2.23(2.17)
PBA: G23456-000
VPD status : Not set
VPD size : 0
NVM update : Update Required
checksum : Valid
Update information
ETrackID: 80000425

The content of nvm.cfg:
CURRENT FAMILY: 1.0.0
CONFIG VERSION: 1.20.0

; NIC device
BEGIN DEVICE
DEVICENAME: Intel(R) Ethernet Controller I226-V
VENDOR: 8086
DEVICE: 125C
SUBVENDOR: 8086
SUBDEVICE: 0000
NVM IMAGE: FXVL_125C_V_1MB_2.32.bin
EEPID: 80000425
RESET TYPE: REBOOT
REPLACES: 80000308
END DEVICE

And the update command:
./nvmupdate64e -b -l nvm.log -m 022626022999 -f -u -c nvm.cfg

Note: tested with various versions of nvmupdate64e, such as 1.43.20.0, 1.43.37, the latest (october 2026), etc.

Update:
I think the problem lies in the output shown by

sudo ./eeupdate64e /NIC=1 /IDFLASH
(EEUPDATE v5.37.01.00)

1: Flash Id: Protected Flash (FAFA) - status: Protected