"
I am a new user to OPNsense comming from using PFsense for years.
I ran into a few issues using OPSense on my Protectli VAULT v1410.
When installing a fresh build initially I had only one issue with regard to a CAM timeout that apears to be a FreeBSD issue. When I removed the USB stick from the usb ports on boot this resolved the issue.
After upgrading to the latest build : 26.7.4_1
I ran into an issue where physical VGA output and serial console access were both lost after initial boot.
The console would show messages and then just stop.
I managed to resolve the console issue with the following:
Issue workaround:
GO into GUI : System → Settings → Administration → Console
Set following:
Primary Console: VGA Console
Secondary Console: Serial Console
Serial Speed: 115200
USB-based serial: UNCHECKED
Console menu: CHECKED
In my system after a fresh install, Secondary console was set to NONE.
I am going to see if I can figure out a workaround for the CAM delay issue when a KVM device is plugged into the firewall.
Ill post back here with results.
I hope this might help anyone with similar issues on this build.
I ran into a few issues using OPSense on my Protectli VAULT v1410.
When installing a fresh build initially I had only one issue with regard to a CAM timeout that apears to be a FreeBSD issue. When I removed the USB stick from the usb ports on boot this resolved the issue.
After upgrading to the latest build : 26.7.4_1
I ran into an issue where physical VGA output and serial console access were both lost after initial boot.
The console would show messages and then just stop.
I managed to resolve the console issue with the following:
Issue workaround:
GO into GUI : System → Settings → Administration → Console
Set following:
Primary Console: VGA Console
Secondary Console: Serial Console
Serial Speed: 115200
USB-based serial: UNCHECKED
Console menu: CHECKED
In my system after a fresh install, Secondary console was set to NONE.
I am going to see if I can figure out a workaround for the CAM delay issue when a KVM device is plugged into the firewall.
Ill post back here with results.
I hope this might help anyone with similar issues on this build.
