Messages

Huh. What does the inbound state look like? I'd expect a pair like this...You cannot view this attachment.

I have not seen this again, after reporting it yesterday.  The other part of the pair was the IPs reversed, with the rule being let out anything from the firewall.  If this happens again I'll be sure to grab a screenshot of the whole pair.

It does follow the correct rules some times.
You cannot view this attachment.

Is this what you are looking for?

These are the 3 rules on the interface
You cannot view this attachment.

These are the aliases
You cannot view this attachment.
You cannot view this attachment.

This what shows in states table
You cannot view this attachment.

I ask this question because I am seeing odd behaviour there.

I have 2 IP addresses in the same subnet, .5 and .50
The .5 address is matching on the firewall rule that has .50 in it, not .5.  The .5 IP should match a rule further down the rules list for that subnet.

I cleared the state table but the exact same issue came back.


Side note
Another odd thing in Firewall:Diagnostics:Aliases it is listing Aliases that no longer exist.  They did exist at one point but have been deleted or renamed, but still show.