Messages

pfry,

I've just found out that be201 and be202 do only work with intel processors 12th generation an highier. So I've changed to a realtek module.

how do I mark this thread as [SOLVED]? Seemingly I can't edit the title.

You are using something FreeBSD based for WiFi while the general opinion here is that something Linux based is the better choice :)

You might just be on to smth :)

They probably just do not end up in /boot/modules but somewhere under /usr/local.

Patrick, thank you, you were right. Files end up in /boot/firmware/... But there is no .ko driver. And I dug deeper to find out that qualcomm wifi is not supported natively not in 14.3 nor in 15.1 FreeBSD.

The wayout would have been to use wifibox, but it is not in the repository of OPNsense.

So I went the BSD way, I guess :) I've read that the least amount of problems you have with an intel wifi be201 or 202 cards. And I've ordered one.

Hi, guys,
I'm trying to setup wifi on my hp260 g2. But I can't figure out how to do it.

I've bought a qualcomm qcncm865 wifi card.
The system recognizes it:

Code Select Expand

pciconf -lv gives me none1@pci0:some numbers. And device name has "wcn" in the name.

I've installed the kernel module:

Code Select Expand

pkg install wifi-firmware-ath12k-kmod-wcn7820_hw20-20260410.
But after install I can't see it in /boot/modules/
I've tried restarting the system. But after the reboot I'm still unable to see anything loaded in

Code Select Expand

kldstat. I can see bluetooth as my adapter is a combination of bluetooth and wifi. But no wifi.

I've tried installing

Code Select Expand

wifi-firmware-ath12k-kmod-qcn9274_hw20-20260410 but it didn't help either.

I'd appreciate your help. What do I do wrong?