"
Hello everyone I have a Lenovo Tiny m910q with I3-7100T and 4GB of RAM. I installed via pci-e a x4 nics rtl8125 card.
In the next month my local isp will hook up fiber optic with up to 2.5GB speed, and I'm getting ready all the hardware.
I started doing some lcoal test and iperf3 between opnsense and a pc results 2.37Gbit/s that seem ok. But using the same pc with linux and creating a PPPoE server is giving awful performance, I cannot get it past 500Mbit/s even with all the optimization recommanded online.
I tried two different pc for the PPPoE server to make sure it wasn't this side bootlenecking (even on a ryzen 9) but I can't get it past that limit. Looking at opnsense host cpu usage during the test it doesn't go over 30% so I don't really get it...
Unfortunatly I do not have any other scenario to test.. I would like to get your input it what might be the cause of this... I would like to get this Lenovo Tiny (opnsense host) to be 2.5GB capable as soon as the connectivity is hooked up
In the next month my local isp will hook up fiber optic with up to 2.5GB speed, and I'm getting ready all the hardware.
I started doing some lcoal test and iperf3 between opnsense and a pc results 2.37Gbit/s that seem ok. But using the same pc with linux and creating a PPPoE server is giving awful performance, I cannot get it past 500Mbit/s even with all the optimization recommanded online.
I tried two different pc for the PPPoE server to make sure it wasn't this side bootlenecking (even on a ryzen 9) but I can't get it past that limit. Looking at opnsense host cpu usage during the test it doesn't go over 30% so I don't really get it...
Unfortunatly I do not have any other scenario to test.. I would like to get your input it what might be the cause of this... I would like to get this Lenovo Tiny (opnsense host) to be 2.5GB capable as soon as the connectivity is hooked up
