Messages

I have Dnsmasq setup as a DHCP Server for some of my VLANs. I also have DHCRelay configured for some VLANs, that should get their IP from my Windows DomainControllers. The VLAN's don't overlap, i specifically set "No DHCP" on Dnsmasq for the VLANs that get relayed via DHCRelay.

Whenever I change something in Dnsmasq and the service (probably) restarts itself, it fails to start. and it says the DHCP Port is already in use. whenever i then just kill the DHCRealy, start DNSmasq and then start DHCRelays again, everything works. When I change something on Dnsmasq again, it fails to start again until i kill the DHCRelay.

How could I fix this?

I stumbled across this thread, since I am also running netbird on OpnSense 26.1 on a VM for my enterprise. I don't think I ever rebooted after installing Netbird but I am kind of scared now. @sopex would you suggest to run your command to everyone that is using NetBird on OpnSense? Since the PR isn't accepted yet. What exactly does the command do?