Messages

Hi, thanks for the answer :)

This is a OPNsense in my lab and it gets a /60 from a higher router.
So there should be enough room for 16x /64 prefixes.

I looked at the WAN interface and I set it to request a /61 prefix, but get a /60. In this situation the OPNsense assigns /63 to any interface where I activate the IA. When I turn it to request a /60 prefix it works fine.
Why this behavior is there? That shouldn´t be like this I think.😅

Hello to the OPNsense community,

I´m new here, but I think I have found a bug in OPNsense 26.1.5.
The new IPv6 address assignment option "Identity Association" assigns a /63 instead of a /64 to the interface.
And also when I choose the 0x1 prefix, it also assigns a /63 which is not correct because the first /63 goes from `0000 - 0001`. So this wont work with multiple /63.

I´m looking forward to get informations if the bug is known already (I don´t found a forum topic about that) or not. :)