"
hi,
i just spun up vm of opensense on proxmox
Versions
OPNsense 26.1.2_5-amd64
FreeBSD 14.3-RELEASE-p8
But when I try to create a port forward with the register rule selected, it doesn't create any entries in the firewall rules table.
I have the reflection for the destination NAT setting checked. I reset opnsense to the default settings with the same result.
WAN is disconnected for now, and i'm only connecting to opn via LAN ip to configure everything from my pfsense config. Any pointers?
Interfaces are assigned (WAN/LAN), but WAN interface on proxmox is disconnected for now before going live.
I'm not sure if I'm doing something wrong, but on my pfsense the same steps create an associated rule.
SOLUTION
NVM, I had to expand the list to see it, since it doesn't expand by default?
i just spun up vm of opensense on proxmox
Versions
OPNsense 26.1.2_5-amd64
FreeBSD 14.3-RELEASE-p8
But when I try to create a port forward with the register rule selected, it doesn't create any entries in the firewall rules table.
I have the reflection for the destination NAT setting checked. I reset opnsense to the default settings with the same result.
WAN is disconnected for now, and i'm only connecting to opn via LAN ip to configure everything from my pfsense config. Any pointers?
Interfaces are assigned (WAN/LAN), but WAN interface on proxmox is disconnected for now before going live.
I'm not sure if I'm doing something wrong, but on my pfsense the same steps create an associated rule.
SOLUTION
NVM, I had to expand the list to see it, since it doesn't expand by default?
