"
Thanks for your help! I realized I forgot to create an extra rule to allow DNS (port 53).
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
25.7, 25.10 Series / Problem with firewall alies
Today at 05:41:14 PM
Hi,
I want to isolate my LAN and OPT1 networks so they cannot access each other. I have tried some configurations, but it doesn't work as expected.
Can someone explain how to set this up correctly?
Right now it only works when I use the 10.0.0.0/24 IP range, but if I add an additional IP address range, I lose my internet connection.
Just to mention, I am a newbie to OPNsense.
Because of limitation of image upload, OPT1 is same firewall rule setup.
I want to isolate my LAN and OPT1 networks so they cannot access each other. I have tried some configurations, but it doesn't work as expected.
Can someone explain how to set this up correctly?
Right now it only works when I use the 10.0.0.0/24 IP range, but if I add an additional IP address range, I lose my internet connection.
Just to mention, I am a newbie to OPNsense.
Because of limitation of image upload, OPT1 is same firewall rule setup.
Pages1
