Messages

Currently one of my hosts is downloading a file at about 1.37kpbs and I see the "in" traffic rate in my "Common" interface. However, on the WAN interface, I see almost the same traffic rate on the "out". There is nothing else going on in my network at this time and I would expect the "in" on both my "Common" and "WAN" to interfaces to match. Am I misunderstanding the "in" and "out" on the interfaces as far as the traffic speed in the Reporting section?

I started with 25.7 and it was working fine for a while and after updating IPS configurations, WebUI became unresponsive and ssh session was disconnected. I can restart the box but both WebUI and ssh would become unresponsive within minutes. I rolled back to 25.1 and the same thing happened but this time I gave enough time after each configuration change and finally narrowed it down to interface setting in Intrusion Detection. Setting IDS to only WAN works but setting it to both WAN and LAN causes this problem. My pi-hole is in LAN and Unbound if set to forward requests to pi-hole. I could not see anything in lighthttpd or system logs after reboot and wondering if someone experienced the same and what might be happening. Is there a log setting I can increase and check logs? Thank you

Router continues to function but I cannot change any configuration after this. I have downloded and enabled all RuleSets but only the default Rules that are enabled by the RuleSets are enabled and I don't have any user defined rules