"Quote from: richaras on July 27, 2026, 01:55:29 AMremove the os-cpu-microcode-intel plugin
I did not expect this to be the solution, but it was. Thanks!!
I removed it also from my other OPNsense appliances to be sure for the future.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
26.7 Series / Re: Update to 26.7 fails and cannot login anymore after some reboots
July 27, 2026, 08:35:10 PMI did not expect this to be the solution, but it was. Thanks!!
I removed it also from my other OPNsense appliances to be sure for the future.
#2
26.7 Series / Update to 26.7 fails and cannot login anymore after some reboots
July 26, 2026, 11:01:08 PM
Hello,
I have several OPNsense firewalls and most of them do upgrade from 26.1 to 26.7 but one fails, scrolling on the console goes very fast, so I captured it in a video and hope that it helps to give me some hints. For now i roll back a snapshot of this opnsense unit.
https://drive.google.com/file/d/1jjizi3W1PxyN8KlQsWSi4uj2NHP8QHeX/view?usp=drivesdk
At 1:30 the config is not loaed, configd is not started? Seen that with other updates as well, but via Ctrl-C (2:28) and after reboot going into single user mode check if config is there and then reboot again solved it for my other routers.
Then at 3:00 i see some errors and I step into single user mode
Then at 5:34 the last part of logging appears with several errors, about dnsmasq and setup_hostwatch.sh and then the login prompt, but the prompt does not accept my password, nor the default opnsense password.
And no WebGUI available as well, as if network adapters are not initialized it seems.
As side note, Zenarmor is installed, but it was installed on another node as well and did not give issues.
What to do?
I have several OPNsense firewalls and most of them do upgrade from 26.1 to 26.7 but one fails, scrolling on the console goes very fast, so I captured it in a video and hope that it helps to give me some hints. For now i roll back a snapshot of this opnsense unit.
https://drive.google.com/file/d/1jjizi3W1PxyN8KlQsWSi4uj2NHP8QHeX/view?usp=drivesdk
At 1:30 the config is not loaed, configd is not started? Seen that with other updates as well, but via Ctrl-C (2:28) and after reboot going into single user mode check if config is there and then reboot again solved it for my other routers.
Then at 3:00 i see some errors and I step into single user mode
Then at 5:34 the last part of logging appears with several errors, about dnsmasq and setup_hostwatch.sh and then the login prompt, but the prompt does not accept my password, nor the default opnsense password.
And no WebGUI available as well, as if network adapters are not initialized it seems.
As side note, Zenarmor is installed, but it was installed on another node as well and did not give issues.
What to do?
Pages1
