"
I'm running into an issue where my upload speeds drop to about 1/2 of my download speeds when there is high network throughput.
Setup:
ISP: Sparklight Fiber (300/300 Mbps)
Firewall: OPNsense 25.1.10 running as a VM on Proxmox
Hardware: Dell OptiPlex 3050 Micro
NICs:
Realtek NIC assigned to LAN
Intel I226-V NIC assigned to WAN
Switch/AP: Unifi Lite 8 PoE switch, Unifi U7 Pro AP
Observed Behavior:
Download speeds are close to ~250-300 Mbps consistently but do drop lower sometimes.
When network throughput is high, Upload speeds typically cap out around 100–150 Mbps, sometimes down into mid to low 10's. For example, when downloading a game on my PS5, my speeds go down to 260/90. I have had it performance plummet even further when playing online games.
This happens even with shaping enabled or disabled entirely (no pipes, queues, or rules).
With shaping enabled (using FQ-CoDel at 280/280 Mbps), performance is slightly improved but upload still lags behind download by a noticeable margin. This could've been a fluke too and it made no difference.
When I pause a large download, download/upload speed jumps back up to 300 Mbps.
Troubleshooting Done:
Verified CPU utilization in OPNsense and increased vCPUs to 4 due to high cpu spikes when shaping was enabled.
Disabled and re-enabled traffic shaping.
Verified both NICs are correctly assigned and visible in Proxmox and OPNsense.
Monitored network stats and resource usage during tests.
Ran multiple Speedtests from different wired clients.
I have also tried to use both PCI pass through and a network bridge for the I226-v NIC.
Question:
What am I missing that could be causing this issue?
Thanks in advance for any help or ideas you can share!
Setup:
ISP: Sparklight Fiber (300/300 Mbps)
Firewall: OPNsense 25.1.10 running as a VM on Proxmox
Hardware: Dell OptiPlex 3050 Micro
NICs:
Realtek NIC assigned to LAN
Intel I226-V NIC assigned to WAN
Switch/AP: Unifi Lite 8 PoE switch, Unifi U7 Pro AP
Observed Behavior:
Download speeds are close to ~250-300 Mbps consistently but do drop lower sometimes.
When network throughput is high, Upload speeds typically cap out around 100–150 Mbps, sometimes down into mid to low 10's. For example, when downloading a game on my PS5, my speeds go down to 260/90. I have had it performance plummet even further when playing online games.
This happens even with shaping enabled or disabled entirely (no pipes, queues, or rules).
With shaping enabled (using FQ-CoDel at 280/280 Mbps), performance is slightly improved but upload still lags behind download by a noticeable margin. This could've been a fluke too and it made no difference.
When I pause a large download, download/upload speed jumps back up to 300 Mbps.
Troubleshooting Done:
Verified CPU utilization in OPNsense and increased vCPUs to 4 due to high cpu spikes when shaping was enabled.
Disabled and re-enabled traffic shaping.
Verified both NICs are correctly assigned and visible in Proxmox and OPNsense.
Monitored network stats and resource usage during tests.
Ran multiple Speedtests from different wired clients.
I have also tried to use both PCI pass through and a network bridge for the I226-v NIC.
Question:
What am I missing that could be causing this issue?
Thanks in advance for any help or ideas you can share!
