Messages

Thanks, I will revert to 25.1 & restore from config file.

After update from 25.1.12 to 25.7, my wireless interface no longer works.

I receive error message:

iwlwifi0: ERROR: lkpi_ic_scan start: hw_scan returned -5

I use OpnSense in transparent bridge mode, with wifi interface used for gateway to internet for OS updates and access to GUI.

As part of troubleshooting, I removed & re-installed: wifi-firmware-iwlwifi-kmod-ax210-20241017.1402000_2.pkg
This did not resolve the problem.

Since I use the wireless interface for internet gateway, perhaps the update to 25.7 is not complete.

Any suggestions how I may correct the problem?

Thanks!

Happy to add the driver to our packages for 25.1.9 now that I now we have a use case for it.


Cheers,
Franco

Thanks!!!

Update:

I downloaded pkg "https://pkg.freebsd.org/FreeBSD:14:amd64/latest/All/wifi-firmware-iwlwifi-kmod-ax210-20241017.1402000_2" on another system to a USB memory.

Installed pkg & rebooted and access via wifi interface is resolved.

When I check firmware status via OpnSense gui, system reports (from OpnSense repository) that system is up to date.

When I check via CLI with 'fwget' command, I receive error of missing pkgs

Perhaps update to 25.1.8_1 removed binaries for the wifi interface, or their there is inconsistency between Opnsense & FreeBSD repositories?

Did update to 25.1.8_1 today and lost access to wireless interface (which is used for Opnsense management via https).

I received messages in during boot "could not load binary firmware /boot/firmware/iwlwifi_s0_a0_hr_b0_89_ucode either
File size way too mall!

Repeats of this message for previous firmware release (88, 87,86,85) occurred in message log before failure / error timeout.

I am using Opnsense as transparent filtering bridge with wifi interface for Opnsense administration GUI as well as gateway to internet.

I did fwget command at CLI and received message that I needed package - 'gpu-firmware-intel-kmod-alderlake gpu-firmware-intel-kmod-tigerlake wifif-firmware-iwlwifi-kmod-ax210

Why was firmware not updated with needed package as part of upgrade process?

Since I only have command line access to Opnsense firewall (and no internet gateway access to add package), how may I correct this issue?

Thanks!