Messages

You could try out:

System: Settings: Administration

Console

Primary Console: VGA Console

Yes, I've checked that and it was set like this already. But still, no luck, at boot it sets to Serial.

I installed OPNSense 25.1 on a Protectli Vault V1410 yesterday and had the same issue. For some reason, the primary console was set to Serial. I had to change it manually to Video during the boot at the main menu in the menu #5. Check the attached image.



I hope it helps others if someone runs into the same issue.

I still don't know how to set it permanently tho. Every time I reboot the device, it sets it back to Serial. If anyone has any ideas, please share them.

Image that I used: OPNsense-25.1-vga-amd64.img.bz2